JOURNAL OF ROCK MECHANICS

JOURNAL OF ROCK MECHANICS

Analytical Investigation of Wellbore–Casing Interaction in a Saturated Poroelastic Medium under Hydrostatic Stress Conditions

Document Type : Original Article

Authors
School of Mining Engineering, College of Engineering, University of Tehran
Abstract
The stability of wellbores drilled in saturated rock formations is an important consideration in the safe design and operation of wells, as it depends on the interaction between the solid skeleton and pore fluid and, consequently, on the time-dependent evolution of stress, displacement, and pore pressure. However, most existing analytical solutions consider the wellbore as an open cavity in a poroelastic medium and do not account for the simultaneous presence of a casing and its interaction with the surrounding formation. This study presents a fully coupled analytical solution for determining the hydromechanical response of a deep circular wellbore with a casing embedded in a saturated poroelastic rock formation. Based on the theory of poroelasticity, the distributions of stress, displacement, and pore pressure in the rock, as well as stress and displacement in the casing, are derived. The analytical solution is verified against finite element numerical modeling using COMSOL Multiphysics, and the effects of the shear modulus, bulk modulus, intrinsic permeability, Biot effective stress coefficient, and porosity on tangential stress are investigated at different times. The results show very good agreement between the analytical predictions and the numerical results for pore pressure, displacement, radial stress, and tangential stress in both the rock and casing. The sensitivity analysis indicates that the shear and bulk moduli have a greater influence on tangential stress near the wellbore, whereas the effects of permeability and porosity reach their maximum at a distance of approximately 1–1.5 times the wellbore radius at short times and remain noticeable at greater distances at longer times. These findings demonstrate that the proposed analytical solution can serve as a tool for evaluating the hydromechanical response of cased wellbores and as a benchmark for verifying numerical models.
Keywords
Subjects

[1]         A. Ibrahim, “A review of mathematical modelling approaches to tackling wellbore instability in shale formations,” J. Nat. Gas Sci. Eng., vol. 89, p. 103870, 2021, doi: 10.1016/j.jngse.2021.103870.
[2]         R. E. Ghahderijani and R. Shirinabadi, “Determining the Optimal Drilling Fluid Pressure for Oil Well Stability Using Geomechanical Modeling in ABAQUS Finite Element Software,” J. ROCK Mech., vol. 9, no. 3, pp. 41–59, 2025, doi: 10.22034/irsrm.2025.504159.0088.
[3]         E. Detournay and A. H. D. Cheng, “Poroelastic response of a borehole in a non-hydrostatic stress field,” in International Journal of Rock Mechanics and Mining Sciences and, Elsevier, 1988, pp. 171–182. doi: 10.1016/0148-9062(88)92299-1.
[4]         A. Abdollahipour and A. Kargar, “THMC Modeling Frameworks in Porous Media: Fundamentals, Applications, and Development of the Displacement Discontinuity Method in Coupled Thermo- Hydro-Mechanical Environments,” J. ROCK Mech., vol. 10, no. 1, pp. 81–101, 2026, doi: 10.22034/IRSRM.2026.587795.1084.
[5]         M. A. Biot, “General theory of three‐dimensional consolidation,” J. Appl. Phys., vol. 12, no. 2, pp. 155–164, 1941.
[6]         M. A. Biot, “Theory of elasticity and consolidation for a porous anisotropic solid,” J. Appl. Phys., vol. 26, no. 2, pp. 182–185, 1955, doi: 10.1063/1.1721956.
[7]         M. A. Biot, “General Solutions of the Equations of Elasticity and Consolidation for a Porous Material,” J. Appl. Mech., vol. 23, no. 1, pp. 91–96, 1956, doi: 10.1115/1.4011213.
[8]         L. Cui and Y. Abousleiman, “Time-dependent poromechanical responses of saturated cylinders,” J. Eng. Mech., vol. 127, no. 4, pp. 391–398, 2001.
[9]         Y. Gao et al., “Cylindrical borehole failure in a poroelastic medium,” J. Appl. Mech., vol. 83, no. 6, p. 61005, 2016.
[10]       A. Abdollahipour, M. Fatehi Marji, A. Yarahmadi Bafghi, and J. Gholamnejad, “A complete formulation of an indirect boundary element method for poroelastic rocks,” Comput. Geotech., vol. 74, pp. 15–25, 2016, doi: 10.1016/j.compgeo.2015.12.011.
[11]       Y. Lu, W. Li, Y. Jin, M. Chen, H. Pang, and W. Zhou, “Short-and long-term wellbore stability analysis for a horizontal well in a transversely isotropic poroelastic formation,” Rock Mech. Rock Eng., vol. 58, no. 1, pp. 767–786, 2025.
[12]       W.-D. Li et al., “Fully anisotropic undrained effects on short-term wellbore stability of arbitrarily inclined wells in transversely isotropic formations,” Pet. Sci., 2026.
[13]       R. Gholami, V. Rasouli, B. Aadnoy, and M. Mohammadnejad, “Geomechanical and numerical studies of casing damages in a reservoir with solid production,” Rock Mech. Rock Eng., vol. 49, no. 4, pp. 1441–1460, 2016, doi: 10.1007/s00603-015-0828-5.
[14]       A. Abdollahipour, M. F. Marji, A. Y. Bafghi, and J. Gholamnejad, “Time-dependent crack propagation in a poroelastic medium using a fully coupled hydromechanical displacement discontinuity method,” Int. J. Fract., vol. 199, no. 1, pp. 71–87, 2016.
[15]       L. Han, F. Yin, S. Yang, W. Liu, and Y. Deng, “Coupled seepage-mechanical modeling to evaluate formation deformation and casing failure in waterflooding oilfields,” J. Pet. Sci. Eng., vol. 180, pp. 124–129, 2019, doi: 10.1016/j.petrol.2019.05.035.
[16]       Z. Xu, P. Lin, H. Xing, D. Pan, and X. Huang, “Hydro-mechanical Coupling Response Behaviors in Tunnel Subjected to a Water-Filled Karst Cave,” Rock Mech. Rock Eng., vol. 54, no. 8, pp. 3737–3756, 2021, doi: 10.1007/s00603-021-02423-0.
[17]       J. R. Rice and M. P. Cleary, “Some basic stress diffusion solutions for fluid‐saturated elastic porous media with compressible constituents,” Rev. Geophys., vol. 14, no. 2, pp. 227–241, 1976, doi: 10.1029/RG014i002p00227.
[18]       A. Verruijt, “Elastic storage of aquifers,” Flow through porous media, vol. 1, pp. 331–376, 1969.
[19]       E. Detournay and A. H. D. Cheng, “Fundamentals of poroelasticity,” in Comprehensive rock engineering. Vol. 2, Elsevier, 1993, pp. 113–171. doi: 10.1016/b978-0-08-040615-2.50011-3.
[20]       A. H.-D. Cheng, Poroelasticity, vol. 27. Springer, 2016.
[21]       T. He et al., “Failure mode of cement sheath in salt cavern gas storge wellbore based on coupling plasticity and damage evolution,” Int. J. Rock Mech. Min. Sci., vol. 160, p. 105272, 2022, doi: 10.1016/j.ijrmms.2022.105272.