JOURNAL OF ROCK MECHANICS

JOURNAL OF ROCK MECHANICS

Comprehensive Slope Stability Assessment of Agh-Darreh Open-Pit Gold Mine (Takab, NW Iran) Using an Integrated Empirical, Kinematic, and Limit Equilibrium Approach

Document Type : Original Article

Author
Department of Mining Engineering; Faculty of Engineering; Science and Research Branch; Islamic Azad University; Tehran; Iran
Abstract
Stable slope design in open-pit mines is one of the fundamental challenges in mining engineering, directly affecting safety, productivity, and project economics. This study aims to comprehensively evaluate the stability of pit walls at the Agh-Darreh gold mine (Takab) using a combination of empirical, kinematic, and limit equilibrium methods. The study was conducted on three main pits (Nos. 1, 2, and 6) and five key wall lines. A total of 259 discontinuities were surveyed and 50 core samples underwent standard rock mechanics tests (including uniaxial and triaxial compressive strength, direct shear, wave velocity, and physical properties). Stability was then assessed using three categories of methods: (1) empirical methods (RMR, MRMR, SMR, and GSI), (2) kinematic analysis (evaluating planar, wedge, and toppling failures), and (3) limit equilibrium analysis in static and pseudo-static states (with a horizontal acceleration of 0.16g). Empirical classifications indicated that rock mass quality is in the "good" to "moderate-to-good" category (RMR=61-65, MRMR=50-53, SMR=71-75, GSI=50-65). Kinematic analysis revealed that the potential for wedge failure is greater than the other two modes, and the probability of all three structural failure types increases with an increase in bench slope angle from 40 to 70 degrees. Limit equilibrium analysis showed that all lines in both static and pseudo-static states have factors of safety above the acceptable limit and are in stable conditions (minimum FOS = 1.56 for Line 4 in pseudo-static state). The current geometric design of the pit walls at the Agh-Darreh mine is safe under static and seismic (0.16g acceleration) conditions. The integrated approach demonstrates high reliability in the results. Establishing a monitoring system and updating the analyses upon the commencement of mining operations are recommended.
Keywords
Subjects

[1] Hoek, E., & Bray, J. W. (1981). Rock Slope Engineering. Institution of Mining and Metallurgy, London.
[2] Read, J., & Stacey, P. (2010). Guidelines for Open Pit Slope Design. CSIRO Publishing.
[3] Eberhardt, E. (2024). Towards Mine Closure: Assessing the Long-Term Stability of Open Pit Mine Slopes. 58th U.S. Rock Mechanics/Geomechanics Symposium, ARMA-2024-1234.
[4] Wyllie, D. C., & Mah, C. W. (2004). Rock Slope Engineering: Civil and Mining (4th ed.). Spon Press, London.
[5] Goodman, R. E. (1989). Introduction to Rock Mechanics. Wiley.
]6[ نقی­پور الف، دهقان ع ن، آهنگری ک (1399). ارزیابی پارامترهای هندسی موثر بر طراحی شیب بهینه دیواره نهایی معدن طلا-مس شادان.‎ نشریه علمی- پژوهشی مهندسی معدن، دوره 15 ، شماره 48 ، پاییز 99 ، صفحه 44-21
]7[ فدایی پ،  دهقان ع ن ، آهنگری ک (1400). مدل‌سازی سه‌بعدی به روش تفاضل محدود برای تعیین اثر پارامترهای هندسی و ژئومکانیکی توده‌سنگ بر پایداری شیب دیواره نهایی معدن طلا-مس شادان. نشریه علمی-پژوهشی مکانیک سنگ ایران، دوره 5، شماره 1، بهار 1400، صفحه 81-67
[8] Chen, Q., Yang, Y. C., Zhu, Q. Y., Li, H. B., Yang, X. G., & Zhou, J. W. (2025). Three-dimensional jointed rock slope stability analysis using integrated block theory and DFN-DEM modeling. Computers and Geotechnics, 188, 107549.
[9] Meng, J., et al. (2024). Editorial for advances in slope deformation and failure analysis methods. Journal of Rock Mechanics and Geotechnical Engineering, 16(3), 745-748.
[10] Bieniawski, Z. T. (1989). Engineering Rock Mass Classifications. John Wiley & Sons, New York.
[11] Laubscher, D. H. (1990). A geomechanics classification system for the rating of rock mass in mine design. Journal of the Southern African Institute of Mining and Metallurgy, 90(10), 257-273.
[12] Romana, M. (1985). New adjustment ratings for application of Bieniawski classification to slopes. International Symposium on the Role of Rock Mechanics in Excavations for Mining and Civil Works, 49-53.
[13] Hoek, E., & Brown, E. T. (1997). Practical estimates of rock mass strength. International journal of rock mechanics and mining sciences, 34(8), 1165-1186.
[14] (2024). Q-Slope: Rock Slope Engineering 10 Years on. Rock Mechanics and Rock Engineering, 57(8), 5891-5912.
[15] Atkinson, L. C. (2000). The role and mitigation of groundwater in slope stability. Slope Stability in Surface Mining, 427-434.
[16] Torabi-Kaveh, M., Mehrnahad, H., Mohammadi, S., & Moosavizadeh, S. M. A. (2023). Application of kinematic and distinct element methods to investigate instability mechanism of rock slopes containing weak and hard layers. Modeling Earth Systems and Environment, 9(2), 2757-2770.
[17] Hoek, E., Carranza-Torres, C., & Corkum, B. (2002). Hoek-Brown failure criterion-2002 edition. Proceedings of NARMS-Tac, 1, 267-273.
[18] Hoek, E., & Karzulovic, A. (2000). Rock mass properties for surface mines. Slope Stability in Surface Mining, 59-70.
[19] Sun, Z., Wang, B., Li, Y., Xu, J., & Ji, J. (2023). 3D limit analysis of rock slopes based on equivalent linear failure criterion with tension cut-off. Journal of Rock Mechanics and Geotechnical Engineering, 15(12), 3118-3130.
[21] Dehghan, A. N., & Khodaei, M. (2022). Stability analysis and optimal design of ultimate slope of an open pit mine: a case study. Geotechnical and Geological Engineering, 40(4), 1789-1808.
[22] Dehghan, A. N., & Yazdi, A. (2023). A geomechanical investigation for optimizing the ultimate slope design of shadan open pit mine, Iran. Indian Geotechnical Journal, 53(4), 859-873.
[23] Hu, S., Li, L., Zhao, L., Zuo, S., & Huang, D. (2023). Strength reduction strategy for rock slope stability using the variation principle based on the Hoek–Brown failure criterion. Bulletin of Engineering Geology and the Environment, 82(8), 297.
[24] Li, H., Gao, J., Wang, Q., & Zhang, H. (2026). Multi-factor coupling analysis of the stability of coal geological slopes in open-pit mines. Journal of Infrastructure Preservation and Resilience, 7(1), 12.
[25] Yadav, A., et al. (2025). Ensemble Machine Learning for Slope Stability Prediction. Rock Mechanics and Rock Engineering, 58(2), 1123-1145.
[26] Arif, A., Zhang, C., Sajib, M. H., Uddin, M. N., Habibullah, M., Feng, R., ... & Zhang, Y. (2025). Rock slope stability prediction: a review of machine learning techniques. Geotechnical and Geological Engineering, 43(3), 124.
]27[ شرکت پویا زرکان آقدره (۱۴۰۳). گزارش زمین‌شناسی محدوده معدن طلای آقدره.
[28] Daliran, F. (2008). The carbonate rock-hosted epithermal gold deposit of Agh-Darreh, Takab, NW Iran. Mineralium Deposita, 43(4), 383-404.
[29] Mehrabi, B., et al. (1999). Mineralogy, geochemistry and fluid inclusion studies of the Agh-Darreh gold deposit, Takab, NW Iran. Journal of Geochemical Exploration, 66(3), 409-423.
[30] Daeijavad, H.A., Asadi, H.H., & Mokhtari, A.R. (2020). Identification and application of a Carlin-type gold mineral system for exploration targeting in the Takab geothermal basin, NW Iran. Ore Geology Reviews, 121, 103494. doi:10.1016/j.oregeorev.2020.103494
[31] Rocscience Inc. (2019). Dips Ver 7.0. Toronto, Ontario, Canada.
[32] SRK Consulting. (2018). Slope Stability Report for Gold Mine Project. Internal Report.
[33] Holt, D., et al. (2020). Slope stability assessment in limestone quarries. International Journal of Rock Mechanics and Mining Sciences, 135, 104-116.
[34] Hoek, E., Carter, T. G., & Diederichs, M. S. (2013). Quantification of the geological strength index chart. In 47th US Rock Mechanics/Geomechanics Symposium. American Rock Mechanics Association.